Line Control Sensors
Machine Control Sensors
Spray Controls
Leak Testers
Oven Loggers
Vision Systems
Fully Automatic Gauges
Semi-automatic Gauges
Coatings Gauges
Front End Can Formation
Coating & Decorating
Back End Can Finishing
3-piece food can lines
2-piece food can lines
Ends making lines
Products for can fillers
Gauging & Measuring | Semi Automatic Gauges | Ends/Caps Enamel Rater
A single unit with interchangeable top plates for easily testing ends, caps and sheets of different shapes and sizes. Works in combination with the SI9100 Semi-auto Enamel Rater.
*PLEASE NOTE: Large end adapter can also be used for smaller ends with a change of top-plate (standard end adapter cannot be used with larger ends).
Due to continual product development, actual specifications may change. E&OE
The latest top plates are magnetically attached for quick and trouble free interchange. The plates, which are affordable and easily stored, are all you need to test ends and caps of different shapes and sizes. Custom top plates can also be made to your specification.
Simple change parts allow testing of a wide range of end types and sizes:
To measure a batch of ends, all the operator needs to do is load the ends one at a time and invert the pot, with no need to push buttons on the gauge
For maximum reliability and durability the adapters are made of plastic and stainless steel with titanium probes that will not corrode.
The SI9020TMR is equipped with test resistors which are controlled by a rotary switch on the side of the unit.
When used with the dedicated SI9100, contacts are verified before every test and any voltage drop in the cables is compensated for so that 6.3 volts is always supplied for the test. This leads to more accurate measurements and better repeatability.
Ends are held in place by vacuum. This is triggered either manually or automaticly just before the probes make contact with the end under test by using the optional SI9023 Vacuum Control unit. This can be useful with large batches as it simplifies and speeds up operation. It also prevents accidental spillage of electrolyte when the adapter is inverted.
SI9200Semi Automatic Enamel Rater
A semi-automatic enamel rater that tests for metal exposure by checking the integrity of coatings or lacquer on metal packaging. See product page for more Information
This reference guide is a collection of useful information relating to the widely used enamel rating test. The test itself is quite simple, but why it works and how to get the best from the test is not necessarily well known.
Multi-EndEnamel Rater
The Multi End Enamel Rater (MEER) carries out fast and reliable checking of lacquer integrity on multiple ends in one pass. Click for more
On-Press Light Tester for Ends
Quasar™ Light Detection is our latest advance in leak detection technology for detecting microscopic defects in ends on the conversion press. Click for more
Micro Leak Testerfor Ends
The Sencon MLT is a high sensitivity on- or off-line sample tester for detecting micro-leaks in converted beverage or food ends using low cost compressed air. Click for more
See me in action
With service engineers based in North and South America, Europe and Asia, backed up by support from our experienced industry specialists at three technical support centers, you can trust Sencon for support, accredited calibration and after-sales service for your Ends/Caps Enamel Rater.
The information you provide will only be used in accordance with our Privacy Statement.
SEND