Area Mass Sensors

Cupping Press Modulation

The AMS monitors cup accumulation on the cupping press discharge or distribution conveyor. The AMS analog output is used to regulate the cupping press’ variable speed drive, adjusting the rate of press strokes based on cup demand.

Conveyor Pressure Control

This is accomplished by varying conveyor speed relative to fill level. When full, the conveyor should run at machine rate, creating no excess can pressure. However, as the conveyor empties, the speed should increase. Thus, when recovering from an empty-out situation, conveyor speed is at a maximum, reducing transit and refill times and adding precious seconds into line efficiency.

Technical Resource Documents (LOGIN REQUIRED)

Product Data Sheet