Coating Thickness Probes
Sencon’s range of probes to accompany the Coating
Thickness Gauge are designed for maximum ease of use and
accuracy of results with flat sheets, formed cans, narrow tubes and aerosols.
Request more information
How to change probe tips
“How to measure 'film weight' in microns”
How Does Coating Measurement Accuracy Save Costs?
If coating weight measurements suffer from a degree of variation, you have to err on the safe side when applying coatings in order to be sure that target weights are met. Therefore a percentage of unnecessary coating is always being applied.
With reliable measurements from Sencon's coating thickness probes, the coating process can be brought under tighter control. Given rising costs, even a small reduction in coatings usage will quickly deliver a return on the investment and save money and raw materials in the future.
Hover Probe (SI9650)
The SI9650 Hover Probe is used with the SI9600 Coating Thickness Gauge to test coating thickness on flat sheets with world class R&R. At the press of a button the probe floats quickly and easily into position on a cushion of air, requiring minimal manual side force to move it to the desired location on the sheet. When the button is released, the Hover Probe simply settles onto the sheet under its own fixed weight, thereby applying the same precise load to the probe tip for every test, giving highly reliable and repeatable readings.
Formed Can Probe (SI9507+)
The SI9507+ Formed Can Probe is used with the SI9600 Coating Thickness Gauge to test internal and external coating thickness on 2-piece Beverage cans. The scissor action jaws are opened manually against spring pressure. Guide rings along the probe arms help the operator to move the can to the correct positions for testing. When the jaws are released, the spring release action applies a consistent and known pressure for each test, avoiding the risk of operator variability and ensuring accurate and repeatable readings.
Formed Tube/Aerosol Probe (SI9560)
The SI9560 is used with the SI9600 Coating Thickness Gauge to measure
the internal and external coating thickness on aerosols or long tubes with very small diameter. Instead of having to cut the tubes open and use the time consuming weigh-strip-weigh method, you can obtain instant results about coating distribution inside formed tubes and aerosols in a non destructive and repeatable way with world class R&R.
-
Thin carbon fibre arms that will go into the tube and remain rigid for precise placement.
Extra small probe heads on the Formed Tube / Aerosol Probe are designed to fit into tubes from 14 mm diameter and up to 220 mm long (internal sizes)
- Very small measurement surfaces to cope with the radial curvature of narrow tubes.
- High precision electronics to process the very small signals involved.
- A dead weight balance to apply the probe tips with careful but consistent pressure onto delicate
tube walls.
NOTE: Due to the small measurement surfaces and the smaller signals involved, the Tube/Aerosol Probe must be used with a modified SI9600 Coating Thickness Gauge. Contact Sencon for details.
Request more information
How to change probe tips
“How to measure 'film weight' in microns
|Deutsch |EspaÑol |FranÇais |Italiano |中文版|
|about us |contact |privacy statement |print this page |